 |
|
|
|
|
|||||||
| PC Power Supply Discussion Troubleshooting and discussion of computer power supplies |
 |
|
|
Thread Tools | Display Modes |
|
#21
04-08-2013
|
||||
|
||||
since you revived this thread. For everyone interested I reviewed this unit with my new setup for the TheLab.gr.
http://www.thelab.gr/power-supplies-...ew-121496.html ps. Of course I complain for the not-FDB fan and some other minor staff  Also check its hold-up time!ps2. The strange result at the last turn-on transient test is due to a setting in my Chromas and not the PSU's fault. In turn-on tests I really miss my old resistor based loader 
Last edited by crmaris; 04-09-2013 at 09:34 AM. 
|
|
#22
04-09-2013
|
||||
|
||||
|
Only 21.8ms hold up time? It's supposed to be 22!
And, for the record, hold up time for the 860 and 760W is actually 24!!! 
__________________
We are stuck with technology when what we really want is just stuff that works. -- Douglas Adams
|
|
#23
04-10-2013
|
||||
|
||||
|
Sorry but according to my equipment is 17.4 and 17.2 ms respectively. And this is a very straightforward procedure, at least for me, to do something wrong (apply full load, cut AC mains and measure the signals on the scope). Please also notice that I run many tests and I take into account only the worst registered time not the best
(e.g. for the AX1200i in a measurement I saw even 25ms!) But since it is above 16 ms I think you should have no worries about it ps. If you want you can resend them to measure their hold-up time again 
Last edited by crmaris; 04-10-2013 at 10:47 AM.
|
|
#24
04-10-2013
|
||||
|
||||
|
You only got 17.4 and 17.2? You're right, that's still good. But that doesn't match the EVT units' performance. I'm going to have to check that.
__________________
We are stuck with technology when what we really want is just stuff that works. -- Douglas Adams
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
