Results 1 to 2 of 2

Thread: Using an ESR meter

  1. #1
    Join Date
    Oct 2008
    Location
    South Africa
    Posts
    91
    Thanks Thanks Given 
    9
    Thanks Thanks Received 
    0
    Thanked in
    0 Posts

    Default Using an ESR meter

    I finally got myself an ESR meter, the Peak Electronics Atlas ESR70. I was using it and it seems like a great piece of kit, but i have found some weird cases with it.

    Was checking some GSC capacitors on a old motherboard, ones known to fail without obvious signs of leaking. So bingo it picks up a high ESR on one of the caps as expected (ESR of about 1.6 on a 1000uf), though test the next one it comes up as fine and i think to myself thats odd. I examine that cap closer and it clearly has leaked out the bottom !
    So i test the ESR and again and it was within spec.

    Now i was testing in circuit, but that did worry me a bit since if the ESR was fine but the cap was definitely failed. The ESR70 cant measure the capacitance in circuit, so i would have to desolder to check the capacitance, but if i need to desolder that kind of defeats the purpose of using the ESR meter.

  2. #2
    Join Date
    Oct 2017
    Location
    Grand Junction, CO
    Posts
    1,592
    Thanks Thanks Given 
    61
    Thanks Thanks Received 
    6
    Thanked in
    6 Posts

    Default

    The ESR70 is a wonderful meter; capacitors are sometimes in parallel and then the a lower resistance will be measured.
    Last edited by ashiekh; 12-22-2017 at 12:53 PM.

Similar Threads

  1. Cheap and Small Power Meter?
    By wannabepsubuff in forum PC Power Supply Discussion
    Replies: 2
    Last Post: 07-24-2014, 10:31 PM
  2. Three-phase meter is defective?
    By Kimjohn8496 in forum Electronic Component Discussion
    Replies: 0
    Last Post: 11-12-2011, 08:51 AM
  3. Integrated Power Meter
    By Mach in forum PC Power Supply Discussion
    Replies: 7
    Last Post: 01-17-2011, 11:39 PM
  4. My new Power Meter :D
    By crmaris in forum Testing Methodology Discussion
    Replies: 4
    Last Post: 12-21-2010, 09:07 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •