Search:

Type: Posts; User: Minerva

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. It really is. 12V simply doesn't move and unlike...

    It really is. 12V simply doesn't move and unlike other supplies it doesn't go above 12V at lower loads.

    I'm surprised the fan runs at 800W given its efficiency. Even so, it's essentially silent.
  2. Thread: AX1600i

    by Minerva
    Replies
    2
    Views
    860

    AX1600i

    Thing's a beast!
    Swapped out a 1600 T2 (the Superflower one) because of whine. Voltages and stability were great.

    The Corsair seems to keep the voltages under lower loads (150W) closer to spec...
  3. Replies
    1
    Views
    1,153

    PC Power supply in disguise?

    Anyone familiar with RV converters? Old ones were big and heavy basically a step down transformer with full wave rectifier and sometimes a regulator, etc.

    Now they use switchers like this one...
  4. LOL if you've got 100VAC on your outlets you...

    LOL if you've got 100VAC on your outlets you really need to get your wiring fixed. If a couple of heat pumps running or whatever is making branch circuits drop that much you may have bigger...
  5. Replies
    19
    Views
    6,249

    That's too bad. I wish it was set it and it was...

    That's too bad. I wish it was set it and it was permanent. Of course if someone set OCP too low they may have a problem. (connect to another PC fix it?)

    In any case, with the 8+4 arrangement on...
  6. Replies
    19
    Views
    6,249

    I do have a question about the link software. If...

    I do have a question about the link software.
    If I set OCP or min fan speed (40%) is it latched, i.e. if I move the supply to another system or use an OS that does not support executable files will...
  7. Replies
    19
    Views
    6,249

    Ok running on REX-V. Having that extra 4 pin on...

    Ok running on REX-V.
    Having that extra 4 pin on the CPU power helps a lot on the draw of the 8 by itself!

    http://i272.photobucket.com/albums/jj170/minervasw/oc11.gif~original

    PCI-E 1A goes to...
  8. Replies
    19
    Views
    6,249

    But this is Asus, the God of all knowing and...

    But this is Asus, the God of all knowing and overclocking stuff! ;)

    I have a FLIR perhaps it's time to take some pix of all this mess.



    I'm reading what the corsair link power menu is...
  9. Replies
    19
    Views
    6,249

    Yes I'm sure it's what caused it. I was using...

    Yes I'm sure it's what caused it. I was using Corsair Link to monitor it and saw it at 29.5A before it suddenly shut down.

    I raised the limit to 40A and have not seen a problem.

    It will hit...
  10. Replies
    19
    Views
    6,249

    My way undersized system trips AX1500i OCP!

    AVS enabled prime95 (I know, I know!) will trip off the OCP at default 30A!

    Could not believe it, not even a serious oc/ov either: 5960X at 4.3 1.25V, Titan X stock, 64GB DDR4 at 2666. That's...
  11. Replies
    12
    Views
    5,500

    Car stereo amp testing bench! :D

    Car stereo amp testing bench! :D
  12. Replies
    11
    Views
    8,051

    Thanks for that!

    Thanks for that!
  13. Replies
    11
    Views
    8,051

    ?? The meter is a lab grade instrument powered...

    ??

    The meter is a lab grade instrument powered off line voltage. It was calibrated 06/12. (Agilent 3458A) I'm 100% sure the voltage is not spec. :lol:
  14. Replies
    11
    Views
    8,051

    Yes I checked the ATX connector on the...

    Yes I checked the ATX connector on the motherboard with a digital volt meter and it's around 3V idle and 2.93V loaded. (F@H)

    System is stable for a few days and then it will just click off and...
  15. Replies
    11
    Views
    8,051

    3.3V reading 2.9V!

    Could this cause the system to randomly shut down?
    Classified X58 board (759) with 990X CPU at 4.2GHz. All other voltages look fine. 3.3V is way too low!
  16. Replies
    26
    Views
    10,361

    Yeah I did try different ground lines with no...

    Yeah I did try different ground lines with no change.
    I dunno, I'm at a loss. Isn't there a Seasonic rep that visits this forum?
  17. Replies
    26
    Views
    10,361

    I guess both of them are defective then because...

    I guess both of them are defective then because both do the same thing. Out of all the other power supplies for these builds I've used (AX1200, HCP1200) I've had no problems with master-slave config...
  18. Replies
    26
    Views
    10,361

    Yep, have one of those Antec ones with the load...

    Yep, have one of those Antec ones with the load resistors. The Seasonic powers on briefly and shuts right off when it's plugged into it too. Never had a PSU do this before.
  19. Replies
    26
    Views
    10,361

    Sure did and it does the same thing. :wall:

    Sure did and it does the same thing. :wall:
  20. Replies
    26
    Views
    10,361

    The second PSU is powering both GTX 590 cards, 8...

    The second PSU is powering both GTX 590 cards, 8 SSDs, 5 HDs, 1BD drive, a aquero controller, flow meters, and 10 1850RPM GTs.

    The first PSU has all the connectors for the motherboard and various...
  21. Replies
    26
    Views
    10,361

    Thanks for the tip! Unfortunately it made no...

    Thanks for the tip!
    Unfortunately it made no change. :(
    It seems like there is some kind of protection that prevents this PSU from running if the motherboard power cable is not connected.
    ...
  22. Replies
    26
    Views
    10,361

    Yes it turns on and shuts right off. Lights and...

    Yes it turns on and shuts right off. Lights and fans come on briefly and shut off.
    Tried it with both supplies and it's the same.
  23. Replies
    26
    Views
    10,361

    Seasonic Platinum 1000W Help needed!

    Is it normal for this supply to turn on briefly and then shut off if the green is jumped to black? (this is always been the standard way to get a supply to run outside of a computer)

    I'm trying...
  24. Replies
    44
    Views
    20,274

    Ultra X4 1600W PSU reviews yet?

    I have a 1600W X3 and have been impressed with its performance. I'm going to get a few more and noticed they have an X4 now that appears similar with a matte finish and braided cable sets instead of...
  25. Replies
    18
    Views
    5,213

    Wow that's pretty shitty compared to the X3...

    Wow that's pretty shitty compared to the X3 1600W. Why would they do this? :rolleyes:
Results 1 to 25 of 77
Page 1 of 4 1 2 3 4