Search:

Type: Posts; User: Mezoxin

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. I was speaking with reference to this link , it...

    I was speaking with reference to this link , it shows the type 3 has 4 12v pins and the type 4 has 3
    https://www.modders-inc.com/power-supply-pinout-repository/8/
    I guess its inaccurate then ,...
  2. i actually prefer the corsair type 3 cables more...

    i actually prefer the corsair type 3 cables more than the type 4 , specially that their pcie cables are more durable as they have the power distributed among 4 pins on the type 3 vs only 3 pins on...
  3. Replies
    20
    Views
    1,076

    its not usual for single rail psu to have 12v OCP...

    its not usual for single rail psu to have 12v OCP as it would have no added benefit other than being a redundant safety feature , the prime titanium 1000w has both 12v OCP and OPP,
    ...
  4. Replies
    22
    Views
    1,951

    its possible , but it was a high setting on both...

    its possible , but it was a high setting on both OPP and OCP since this is a clear deviation from the design by seasonic it could be a problem with Antec's QA
  5. Replies
    22
    Views
    1,951

    It is a focus based unit , but it did have its...

    It is a focus based unit , but it did have its discrepancies between it and the focus , it had its OPP set too high which caused the first review sample to fail when tested by Aris , and the OCP for...
  6. Replies
    22
    Views
    1,951

    users of the antec HCG 850w also notice a...

    users of the antec HCG 850w also notice a distinctive rattling noise at start
    it uses the 120mm Fluid Dynamic Bearing Fan (HA1225H12F-Z) so i guess that explains it
  7. Replies
    22
    Views
    1,951

    I've seen some people on the forums complaining...

    I've seen some people on the forums complaining about the same thing in the corsair RM 2019
  8. well if it can be done by adding PTC resistors in...

    well if it can be done by adding PTC resistors in cable for the peripheral , or the preferred way of adding more specific supervisor IC and shunt resistors 24 pin and peripherals , that was a very...
  9. more OCP shuts sounds like the ideal solution ...

    more OCP shuts sounds like the ideal solution
    What are the dangers if power is cut off from a single PC component while the rest is still running , letts say sata powered HDD what are the hardware...
  10. would it allow for transients though without...

    would it allow for transients though without affecting its output significantly ?
  11. I think that's a great idea , or maybe in cable...

    I think that's a great idea , or maybe in cable so it would be more specific ? is this doable ?
  12. I agree and wish such optimisations could be...

    I agree and wish such optimisations could be implemented in digital PSU's
    but when in comes to households CB you have different consequences there (that could cause a large fire and multiple...
  13. you are correct the way that OCP is configured ...

    you are correct the way that OCP is configured in general wont protect against all scenarios

    but that specific failure was caused intentionally by using aftermarket adaptors and bypassed the...
  14. it wont kick in because that pin is rated for 8A

    it wont kick in because that pin is rated for 8A
  15. https://linustechtips.com/main/topic/1145932-used-...

    https://linustechtips.com/main/topic/1145932-used-psu-with-melted-satas/

    This HX1200 had 3 molten peripheral connectors , why would anyone use adaptors on this unit
  16. youtube algorithm just decided to show me this to...

    youtube algorithm just decided to show me this to piss me off


    https://www.youtube.com/watch?v=zw5KfDq0C_Y
  17. if you look at the 6pin aux pinout you will see...

    if you look at the 6pin aux pinout you will see the problem , it has a single 12v pin (yellow box)
    those two 12v wires on the molex are sourced (daisy chained) from a single 12v pin on the back of...
  18. Purely driven by aesthetics i see , at least that...

    Purely driven by aesthetics i see , at least that is a lot safer than molex
  19. that is sad , i don't know why gpu manufacturers...

    that is sad , i don't know why gpu manufacturers allow for such user error when clearly the molex cables/connectors are not capable of safely handling the power draw of the pcie 8 pin
  20. its a shady seller on the internet , he says that...

    its a shady seller on the internet , he says that he fried that connector when he used it to power a gpu , yet he claims he didn't use it for mining , bottomline is you should never use adaptors ,...
  21. its an RMi850 , it was probably for a mining rig...

    its an RMi850 , it was probably for a mining rig , because I donít see any other case that a person found himself out of the already available 6 x 8pin pcie connectors that come with an rmi 850w
  22. doesn't really matter if it was one or two or...

    doesn't really matter if it was one or two or even 4 as long as he uses them from the same cable , all of these are sourced from a single 12v pin in the back of the psu
  23. Why you shouldn't use a well made 4 pin molex to (6+2)8pin pcie adaptors

    Why you shouldn't use 4pin molex to (6+2)8 pin pcie connectors , specially if they are well made
    This is a great example of a person that bought a quality adaptor that took the beating , but sadly...
  24. https://i.imgur.com/Oyj9fUg.jpg ...

    https://i.imgur.com/Oyj9fUg.jpg


    https://youtu.be/snubTs5JPZc?t=97
  25. from Aris PSU 101 guide " In some...

    from Aris PSU 101 guide

    " In some larger-capacity PSUs, there are two main transformers, instead of one, installed in parallel, simply because a single transformer would have very large...
Results 1 to 25 of 69
Page 1 of 3 1 2 3